However once I saved and exited from BIOS, my PC restarted and for some reason my monitor once again had "No Signal," and nothing happened after that, so I just turned off my PC. Thus bringing me back to the guide, where I followed the "Deploying the Recovery Media" section and went into my BIOS and set it to boot from my Sandisk USB drive, which is where I stored the rescue media. At first I thought I was basically screwed and since I had the free time, I just decided to do the cloning process again from the beginning of the guide, however now there seems to be a file or something that says "System Reserved." So, once I got to the end of the cloning process with Macrium Reflect, unlike before, now this message popped up: My monitor just lost signal and my peripherals (keyboard and mouse) lost power, and after a few minutes of waiting, nothing happened, so I decided to turn off my PC and turn it back on. I've been following this guide: Ĭloning software used: Macrium Reflect, just like in the guideĮverything seemed to be going well up until it reached the halfway point in the cloning process. As of right now, I'm trying to replace/clone my old hard drive with my new hard drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |